|
|
All Tags » install ( RSS)
-
|
I don't know about most of you but I had no idea my car had a cabin air filter . I just so happened to be recording an oil change in my maintenance log when I noticed that Ford recommended that the cabin air filter be changed every 12 months . After a lot of Googling I was a little perplexed on where the cabin air filter went. After a quick call...
|

jjimenez
|
-
|
Tools Needed: wrench sockets – 10mm, 12mm, 13mm, 15mm, 18mm (deep), 19mm (deep) jack and jackstands Spring compressor Spring installs on the new S197 body are extremely easy; especially after doing a few sets now. I did this last set in a little over an hour and that includes taking notes and a few pictures. With the install I used a set of GT500 STRUT...
|

jjimenez
|
-
|
This weekend I finally got around to installing a set of inner and outer door belt weatherstrip on my '89 Chevy C1500. As you can see in the picture below, I am a few years late in getting around to this but better late then never I guess. At LRS we sell the complete inner and outer door belt weatherstrip kit for $54.95. Door belt weatherstrips...
|

nate
|
-
|
If you have been considering an upgrade for you cooling system, the Mishimoto Radiator is a great buy! I just got done installing one on 2003 Mustang GT. The radiator that was used was a MIS-RADMUS97 , it fits 97-04 Mustang GTs, Cobras and Mach 1s with manual transmissions. I was very surprised at how well the radiator fit. The cooling system gets nearly...
|

jjimenez
|
-
|
I had the pleasure of installing a set of JBA headers part number JBA-1850S and a JBA catback part number JBA-403005 on my 2000 5.3 reg cab this week. Talk about a cakewalk!! I had the catback on in an easy half hour in my driveway, and the headers in 2. I also took the time to go ahead and have a muffler shop cut my factory cats off and install some...
|

scott s
|
-
|
I just purchased a Canton coolant expansion tank (fits 96-04 2v and 4v motors). Part # CAN-80232 . The installation went great and was very easy to install. Simple hand tools will be needed as well as a large catch pan for the coolant. The welds and over all appearance in the engine bay are very nice. It really makes the car stand out when you open...
|

jjimenez
|
|
|